Checkline DT-5TS Instrukcja Użytkownika Pobierz pdf (Strona 6)

Factory Settings

The following charts reflect the default parameter and function settings as programmed by the factory:

Operating Mode -01- (RPM or Rate Measurement)

Panel Installation

Install the DT-5TXR/DT-5TS on panel as follows:

1. Confirm that the panel thickness is 0.047” - 0.197” (1.2 mm - 5 mm).

2. Remove the two mounting adapters (provided) from the DT-5TXR/DT-5TS (diagram 2).

3. Install a water-resistant gasket on the panel (see diagram 3 & 4).

4. Hold the panel meter in a horizontal position, insert it into the cut-out and press against gasket (diagram 5).

5. Replace the two mounting adapters (diagram 6).

6. The DT-5TXR/DT-5TS is secured on the panel by using the two mounting screws (provided) (see diagram 7).

3 margaid2 margaid

7 margaid6 margaid5 margaid

diagram 4

DISPLAY

1 Pulses

er revolution

_ _

0001 1

2 Sensing RPM _ 01000 1,000 RPM

3 Display units 1000 1,000

4 Update time _ 1.0 _ 1 second

5 Display “Hold” after input signal ceases

_ _

006.0

6 seconds

6 In

ut filter

10 kHz

DEFAULT FACTORY SETTING

PARAMETER DESCRIPTION

DISPLAY

MEANING

1 The 2nd HI and 2nd LO limit setting 0 0 0 0 0 0 0

2 Hysteresis of 1st HI and 1st LO set _ _ _ _ 0 0 0

3 Secures the 1st HI and 1st LO set

Not secured

4 Out

ut activation of an

set limit

_ _ _ _

0 0 0 seconds

5 Selection of secondar

dis

1st HI and 1st LO limit set

6 Main display shows 0 below this no. setting 0 0 0 0 0 0 0

7 Averages the sensor output frequency _ 0 _ None

8 Deceleration to ZERO display value

_ 0 _

Off

10 Logic of BCD output _ 0 _ Negative-true logic

11 Analog output value 0 0 1 0 0 0. 1000

12 Minimum value of analog output 0 0 0 0 1 0. 10

13 Update time for analog output

About 10 msec

14 Offset for analo

out

0 0 0.0 0%

DEFAULT FACTORY SETTING

Output modules (DT-5TXR only)

FUNCTION

DESCRIPTION

MEANING

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Checkline DT-5TS Instrukcja Użytkownika Strona 6

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Checkline DT-5TS