Checkline KXE Instrukcja Użytkownika

– 1 –Table of Contents1.0 Introduction ... 0

– 10 –Memory mode “C” CONTINUOUS:The following values of a measuringperiod are calculated and all readings are additionally saved at a rate of 2 readi

– 11 –6.1 Memory Mode Selection1. Turn on the tension meter and clear the memory by simultaneously pressing the MEM and RECALL keys.2 Press a

– 12 –While the tension data are stored, the MEM indicator blinks ฀฀฀฀฀฀฀฀฀฀฀฀฀3฀฀Mem on the display and the currently measured value is displayedTo s

– 13 –To stop data logging:When you want to end the measuring period, press the MEM key once again. The statistical values are calculated from the log

– 14 –To stop data logging:When you want to end the measuring period, press the MEM key once again. The statistical values are calculated from the log

ELECTROMATIC E Q U I P M E N T C O., I N C.600 Oakland Ave., Cedarhurst, NY 11516 – USA TEL:฀฀516-295-4300฀฀฀•฀฀฀FAX:฀฀516-295-4399CHECK•LINE®INSTRU

– 2 – Important Operating NotesTo avoid damage, do not move the center roller by hand.Tensions that exceed the tension range of the instrument by mo

– 3 –1.0 IntroductionThe KXE Warp Tension Meter is designed to measure tensions during warping and weaving. The unique sensor configuration provided t

– 4 –2.0 Overview – 25 –12.0 SpecificationsDisplay Unit Calibration According to factory procedureUnits of Measure daNAccuracy ± 1% FS* ± 1 digi

– 5 –3.0 Set-Up Procedures3.1 Battery insertion and replacementBefore the first use of your tension meter, you need to insert the battery1. Open th

– 6 –Measuring with the display unit in the right hand (default position):1. Tension meter switched off as described in Chapter 3.22. Press and

– 7 –4.0 Taking A Measurement4.1 Inserting the process material1. Turn on the power, then perform as zero adjustment as described in Section 3.4.

– 8 –5.0 Damping ModeThe KXE is equipped with an electronic damping which ensures steady readings when tension fluctuates. This is achieved by averagi

– 9 –5.3 Setting a new Damping Factor1. Press and hold the DAMP key. The display shows the set damping factor.2. You can now increase the damping